Descrizione

In the Linux kernel, the following vulnerability has been resolved: drm/nouveau/nvkm: clear use.enabled when subdev init fails On Kepler boards without the video decode falcon firmware installed (msvld/mspdec/msppp), every other VA-API decode attempt binds to an engine with no ucode loaded. The submitted work never completes, which leads to a context switch timeout, a channel recovery that cannot reset the engine, and eviction waits on fences that never signal. The process ends up stuck in D state, or killed by SIGBUS when it touches a buffer evicted after the wait times out: msvld: unable to load firmware data msvld: init failed, -19 fifo: SCHED_ERROR 0a [CTXSW_TIMEOUT] vo[5444]: channel 14 killed! WARNING: drivers/gpu/drm/nouveau/nvkm/engine/fifo/runl.c:117 at nvkm_runl_rc+0x2a4/0x3b0 [nouveau] [TTM] Buffer eviction failed WARNING: drivers/gpu/drm/nouveau/nouveau_bo.c:1092 at nouveau_bo_move_ntfy.part.0+0x9b/0x100 [nouveau] Tracing nvkm_subdev_ref() and nvkm_subdev_init_() shows the pattern: a reference taken with enabled=0 runs nvkm_falcon_init(), which returns -ENODEV; the next reference sees enabled=1 and succeeds without running it. Clear use.enabled when init() fails, so that every later reference retries init and fails cleanly. The other readers of use.enabled are fini() handlers that use it to skip teardown, which they now also do after a failed init(). On a GK107 (Quadro K1100M) without video firmware, playing H.264 with mpv --hwdec=auto: without this patch the GPU channel is killed within a minute and mpv hangs; with it, VA-API decoder creation fails, mpv falls back to software decoding, and no faults are logged.

Testo originale del record CVE (in inglese).

Come correggere

Priorità: Bassa — correggere con la manutenzione ordinaria. Motivazione: EPSS 0.2% (percentile 6).

Versioni da aggiornare

  • Linux Linux: versione corretta 6.12.118 (o successiva).
  • Linux Linux: versione corretta 6.18.64 (o successiva).
  • Linux Linux: versione corretta 7.3.5 (o successiva).
  • Linux Linux: versione corretta 7.4-rc2 (o successiva).
  • Linux Linux: vulnerabile la versione 6.2 → installare l'ultima release supportata dal vendor.

Mitigazioni temporanee

Da applicare solo se non è possibile aggiornare subito:

  • Ridurre l'esposizione del componente vulnerabile (segmentazione, accesso solo da reti fidate) finché la patch non è applicata.

Verifica

  1. Individuare tutti gli asset con il prodotto interessato (inventario, scanner di vulnerabilità, CMDB).
  2. Confrontare la versione installata con quelle indicate sopra.
  3. Applicare l'aggiornamento in un ambiente di test, poi in produzione; riavviare i servizi se richiesto.
  4. Ripetere la scansione per confermare la correzione.

Configurazioni interessate

VendorProdottoVersioni vulnerabiliCorretta in
Linux Linux — 6.12.118
Linux Linux — 6.18.64
Linux Linux — 7.3.5
Linux Linux — 7.4-rc2
Linux Linux 6.2 —

Riferimenti