Descrizione
The ITE IT8xxx2 SHI host-command backend in subsys/mgmt/ec_host_cmd/backends/ec_host_cmd_backend_shi_ite.c arms the SPI peripheral before its receive context exists. shi_ite_init_registers() sets the state machine to SHI_STATE_READY_TO_RECV and calls irq_enable() while the device initializes at POST_KERNEL priority CONFIG_KERNEL_INIT_PRIORITY_DEFAULT (40), but data->rx_ctx and data->tx are only assigned later by shi_ite_backend_init(), which ec_host_cmd_init() invokes at CONFIG_EC_HOST_CMD_INIT_PRIORITY (default 80). If the attached host processor starts a SPI transaction inside that window, the Rx-valid-length interrupt fires, shi_ite_int_handler() passes its state check and calls shi_ite_parse_header(), which stores the host-derived request length through the still-NULL data->rx_ctx. On the IT8xxx2 low addresses are not backed by RAM, and with CONFIG_NULL_POINTER_EXCEPTION_DETECTION_PMP the first bytes of the address space are explicitly made inaccessible, so the store raises a fatal access fault in interrupt context. The window widens further when CONFIG_EC_HOST_CMD_INITIALIZE_AT_BOOT is disabled and the application calls ec_host_cmd_init() itself. The result is a kernel panic on the embedded controller: with Zephyr's default fatal handler the CPU halts, so the controller stops servicing host commands until a hardware reset. Because the trigger is traffic from the attached host processor -- an untrusted peer from the controller firmware's point of view -- software on that host can provoke the fault by forcing a controller reset and issuing transactions during the reboot, turning a recoverable reset into a persistent outage. Impact is limited to availability: the faulting address is fixed and not attacker-chosen, so no memory-corruption primitive follows. The fix leaves the interface at SHI_STATE_DISABLED with the interrupt masked during device init, moves irq_enable() into shi_ite_backend_init() after the buffers are published, and makes shi_ite_int_handler() reject a NULL data->rx_ctx while write-clearing IT83XX_SPI_ISR and IT83XX_SPI_RX_VLISR so that an unexpected early interrupt cannot storm.
Come correggere
Priorità: Bassa — correggere con la manutenzione ordinaria. Motivazione: CVSS 4.7, EPSS 0.1% (percentile 1).
Versioni da aggiornare
Il record non riporta ancora i prodotti e le versioni corrette (analisi NVD in corso). Consultare l'advisory del vendor nei riferimenti.
Mitigazioni temporanee
Da applicare solo se non è possibile aggiornare subito:
- Ridurre la superficie esposta (disattivare servizi e funzionalità inutilizzati), mantenere attive le protezioni del sistema operativo (ASLR, DEP/NX) e segmentare la rete.
Verifica
- Individuare tutti gli asset con il prodotto interessato (inventario, scanner di vulnerabilità, CMDB).
- Confrontare la versione installata con quelle indicate sopra.
- Applicare l'aggiornamento in un ambiente di test, poi in produzione; riavviare i servizi se richiesto.
- Ripetere la scansione per confermare la correzione.