Descrizione

Improper verification of cryptographic signature (CWE-347) in the firmware update handler of the management service (uavmonitor_usbv1) of the 1300 communications board in DJI AeroScope Mobile (TP703) firmware 03.00.00.26, with 1300 communications board firmware 02.00.07.12 through 02.00.08.40, allows an unauthenticated attacker on the local network to install modified firmware, which gives persistent code execution as root. The device accepts any image that matches an MD5 checksum supplied in the same request and does not verify a signature. Exploitation requires network access to TCP port 16000 on the board and that the unit is not connected to another controlling host. Reproduced by running the unmodified device binaries in emulation; not tested on a physical device. NOTE: This vulnerability only affects products that are no longer supported by the maintainer. DJI has discontinued AeroScope Mobile and no fixed firmware is available.

Testo originale del record CVE (in inglese).

Come correggere

Priorità: Media — correggere nel prossimo ciclo di patch. Motivazione: CVSS 8.8, EPSS 0.1% (percentile 3).

Versioni da aggiornare

  • DJI AeroScope Mobile (TP703): vulnerabile la versione 03.00.00.26 → installare l'ultima release supportata dal vendor.
  • DJI AeroScope Mobile (TP703) 1300 communications board firmware: vulnerabili le versioni dalla 02.00.07.12 fino alla 02.00.08.40 inclusa → aggiornare a una release successiva alla 02.00.08.40.

Indicazioni del vendor

Soluzione (testo originale del vendor):

DJI AeroScope Mobile has been discontinued and is no longer supported by DJI. No fixed firmware is available. Operators should plan to replace affected units with a supported product and, until then, apply the workarounds.

Workaround (testo originale del vendor):

Connect the unit's management Ethernet port only to an isolated network segment with no untrusted hosts, and do not route or bridge that segment to other networks, so that TCP port 16000 and the multicast discovery traffic (225.0.0.37, UDP port 16001) cannot be reached. The device has no setting that enables signature checking of firmware updates.

Mitigazioni temporanee

Da applicare solo se non è possibile aggiornare subito:

  • Ridurre l'esposizione del componente vulnerabile (segmentazione, accesso solo da reti fidate) finché la patch non è applicata.

Verifica

  1. Individuare tutti gli asset con il prodotto interessato (inventario, scanner di vulnerabilità, CMDB).
  2. Confrontare la versione installata con quelle indicate sopra.
  3. Applicare l'aggiornamento in un ambiente di test, poi in produzione; riavviare i servizi se richiesto.
  4. Ripetere la scansione per confermare la correzione.

Configurazioni interessate

VendorProdottoVersioni vulnerabiliCorretta in
DJI AeroScope Mobile (TP703) 03.00.00.26 —
DJI AeroScope Mobile (TP703) 1300 communications board firmware ≥ 02.00.07.12 ≤ 02.00.08.40 —

Riferimenti